Simple CNC pendant
This simple and easy to use CNC control pendant is extremely easy to setup and use. It features a splash-proof membrane switch cover and is fitted with a curly chord that connects to your PC via USB.
It works and is fully compatible with Mach3 and our CNC3D Commander software. These hand controller pendants are recognized by computer systems as a keyboard and simulate key presses. No additional drivers or software is required to get these units to operate, simply plug in and play.
Most required functions are covered with this unit including:
1. Emergency Stop
2. X, Y, Z and A Directional Motion Controls
3. Feed Rate Control
4. Jog Rate Control
5. Spindle Speed Control
6. Spindle On/Off
7. Cycle Start (G Code)
8. Stop(G Code)
9. Original Point
10. Motion Step
PLEASE NOTEBe careful when leaving these units plugged in as they may send keys in other windows where it isn't desired when accidently pressed.