top of page
TurboCut 2 Flute Straight cut endmills for wood

TurboCut 2 Flute Straight cut endmills for wood

Rating is 5.0 out of five stars based on 1 review
PriceFrom $6.00
GST Included

 

All of our TurboCut endmills are sent via Australia post express for speedy replacement

 

These 2 flute straight cut endmills are designed for milling and engraving materials that tend to splinter such as wood. They are specifically designed to keep swarf in the cutting track without removing it. Using Upcut or downcut endmills on wood will often leave a burred edge on either side of the job. These endmills are designed to stop this from happening. 

 

 

Recommended for

 

  • Wood & timber (MDF, ply, hardwoods)
  • Plastics (ABS, HPDE, Delrin and other softer plastics) 

 

Please Note

Be careful when cutting or engraving MDF and some particle timber products as they produce a lot of fine dust that can irritate the throat, eyes and lungs. It is recommended to use a dustshoe and suitable dust extraction system when machining these products.

 

Please be aware that the 8mm variants of these endmills will not fit in an ER11 collet such as those that are standard with a CNC3D QueenBee or QB2 machine. The maximum size cutting bit that will fit in your ER11 collet is 7mm.

  • Specifications

    Endmill Size Total Overall Length
    2 x 12 x 3.175mm 38mm
    3.175 x 22 x 3.175mm 50mm
    4 x 22 x 4mm 50mm
    4 x 32 x 4mm 60mm
    6 x 32 x 6mm 75mm
    6 x 52 x 6mm 100mm
    8 x 32 x 8mm 75mm
    8 x 62 x 8mm 100mm

     

    ** These are approximate overall lengths. This information should only be used as a guide. We recommend measuring the bit after you receive it for exact measurements **

Reviews

Rated 5 out of 5 stars.
Based on 1 review
1 review

  • RoddersAug 26
    Rated 5 out of 5 stars.
    Verified
    As good as any and better than many.

    As good as any and better than many.

bottom of page