Hi using a 4030 machine and your commander software and xyz probe. Setup has been fine till today when attempting to home machine it is not activating the z limit switch and i have to emergency stop the machine. I switched over to a grbl controller the machine came with and it homes perfectly with that. What is happening ?
top of page
bottom of page
Can you upload a photo of your controller?
sainsmart 4030
Which machine do you have? We've seen this before on machines that have limit switches that aren't electronically filtered.
Actually tried homing with other sender last night on 3rd attempt went past homing on Z. So it cant be software a but controller error, as if i manually hit the limit twice and it register's in the sender ,hit unlock then home it works. thanks for help
Ok, Can you confirm the command the other sender is sending to home?
As in soft limits tab?, i dont have it enabled but
x=420
Y=310
z=110
Hey Krupt, What is your maximum travel settings in the peripherals tab? Homing will always be 1.5x that value.